[Coco] Drivewire not allowing disk access of drive 1-3

[rietveld rietveld]

So there is a difference between HDB-DOS LBA that I use with the superIDE and ‎HDB-DOS DW3 that I use with my drivewire server

Anyway it all works now. Thank you Aaron

Sent from my BlackBerry Passport Red Edition.
  Original Message
From: Aaron Wolfe
Sent: Sunday, February 25, 2018 10:59 PM
To: CoCoList for Color Computer Enthusiasts
Reply To: CoCoList for Color Computer Enthusiasts
Subject: Re: [Coco] Drivewire not allowing disk access of drive 1-3


This is how HDBDOS works and is normal.

Either enable "HDBDOS mode" in Drivewire, or use the DRIVE # commands as
described in hdbdos documentation.  It's not what most ppl expect, but it
is standard for this scenario.

-Aaron


On Feb 25, 2018 10:42 PM, "rietveld rietveld" <rietveldh at hotmail.com> wrote:

Hi. My hard drive died on my Drivewire server PC. I replaced it and did a
fresh install of XP( same OS as before).    I placed the DriveWire
application on the desktop along with a folder holding all of my. Dsk's. I
can 'insert' a. Dsk into any of the four drives but only Drive 0 shows the
directory when I type DIR. Drive 1-3 show that they are empty.    I can
copy drive0 to any other drive (1-255)


Sent from my BlackBerry Passport Red Edition.

--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco

--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco