[Coco] Glenside IDE Boards price reduced and for sale at the show.

secure at ytunnelpro.com secure at ytunnelpro.com
Sat Apr 3 18:07:40 EST 2004


On 4/3/2004, "Mark Marlette" <mmarlett at isd.net> wrote:

>HDB-DOS 1.1 supports the Glenside and SuperIDE Interfaces. In IDE mode
>support for CHS and LBA modes, master and slave. No EPROM required for the
>SuperIDE. Utilities come with the device to allow you to FLASH your own
>programs into any of the four available ROM cartridge areas. Takes about
>12seconds off the floppy, much faster off the hard drive.


Any change of getting the drivers into KAOS? It's already RS-DOS
compatible would be a matter of swapping the dskcon routines and making
an extra drive select table. Iv'e written IDE ATAPI drivers for OS-9000
but that was in C - not like there's really a whole lot to writing an
IDE driver though.



More information about the Coco mailing list