[Coco] CoCoSDC and Extended ADOS3

[Ron Klein]

Hi Darren,

I did just as you instructed and saw the DK in the upper left corner of the
screen.  The ADOS3 image I created must be bad so I'll attempt to do it
again and let you know how it turns out.

Thanks so much for all your help, sir!

-Ron


On Mon, Nov 28, 2016 at 11:45 AM, Darren A <mechacoco at gmail.com> wrote:

> On Sun, Nov 27, 2016 at 5:29 PM, Ron Klein wrote:
>
> > Hi Darren,
> >
> > I'm finally back home (after being out of town all last week) and had a
> > chance to try using your instructions for flashing the Extended ADOS3
> file
> > I have to the CoCoSDC.  I was able to flash the image without issue, but
> it
> > crashes the Coco 3 when I do a RUN @7.
> >
> > The image I'm trying to flash is the one generated using Art's ADOS setup
> > program.  Not sure if the image needs to be modified in order for it to
> > run.
> >
> > Any other things for me to check?
> >
> > Thanks again for your help!
> >
>
>
> First I would suggest checking to make sure that the data flashed into bank
> 7 came from a properly loaded and aligned BIN file.  With the WIDTH 32
> screen mode active, enter the following command:
>
> COPY MEM @7, &HC000, 1024, 2
>
> This will copy the first 2 bytes from bank 7 to the top-left of the
> screen.  You should see DK as the first 2 characters on the screen. If not,
> then something about the way you created/loaded/flashed the BIN file was
> not correct.
>
>
> - Darren
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>