[Coco] CoCoSDC on TANO Dragon

[rietveld rietveld]

You can check what version of sdc dragon dos you have by flipping the DRAGON dip switch up (on) and jumping the centre pin to the DRQ pin and turning the dragon computer on    If it says dos.03 then you will need to flash dosplus 5.0

Sent from my BlackBerry — the most secure mobile device
From: rietveldh at hotmail.com
Sent: August 4, 2020 9:13 AM
To: coco at maltedmedia.com
Reply to: coco at maltedmedia.com
Subject: Re: [Coco] CoCoSDC on TANO Dragon

If your sdc is less then a few years old it will already have DOSPLUS 5 on it.   you just need to add the boot spacebar program to the autoexec file

https://youtu.be/sj1X0g494vA


Sent from my BlackBerry — the most secure mobile device
From: varmfskii at gmail.com
Sent: August 4, 2020 8:50 AM
To: coco at maltedmedia.com
Reply to: coco at maltedmedia.com
Subject: Re: [Coco] CoCoSDC on TANO Dragon

So, I need to put the raw bin from someplace like colorcomputerarchive,,
write a program to put it into memory, use the sdc-doc commands to write it
to one of the banks on the sdc, then set the jumpers and I should be good?

On Tue, Aug 4, 2020, 06:02 rietveld rietveld <rietveldh at hotmail.com<mailto:rietveldh at hotmail.com>> wrote:

> You need to move both jumpers .    also if you are using an older SDC then
> you should upgrade the rom to DOSPLUS 5.0.     when You run 5.0 you can
> autostart SDCX
>
>
> SDC jumper settings for a Tano Dragon https://imgur.com/gallery/YedO8GD
>
>

--
Coco mailing list
Coco at maltedmedia.com<mailto:Coco at maltedmedia.com>
https://pairlist5.pair.net/mailman/listinfo/coco

--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco