[Coco] Nitros9 boot disk

rietveld rietveld rietveldh at hotmail.com
Sat Apr 7 13:29:19 EDT 2018


I am hoping one of eds mini mpi,s will  solve the 'y' cable issue by letting me select the controller (disto or SDc) ‎. I hope the MPI will let Nitros9 see only the SDC at bootup

Sent from my BlackBerry Passport Red Edition.
  Original Message
From: L. Curtis Boyle
Sent: Saturday, April 7, 2018 1:24 PM
To: CoCoList for Color Computer Enthusiasts
Reply To: CoCoList for Color Computer Enthusiasts
Subject: Re: [Coco] Nitros9 boot disk


If I remember correctly, a Y cable doesn’t like having two pieces of hardware at the same address (which a floppy controller and the CocoSDC, since it emulates one, would be), so they will argue with each other as to who is supposed to respond. Y cables were more meant for hardware at completely different addresses (and fully decoded).

L. Curtis Boyle
curtisboyle at sasktel.net



> On Apr 7, 2018, at 10:48 AM, rietveld rietveld <rietveldh at hotmail.com> wrote:
>
> Quick question for the Nitros9 guys
>
> I Boot up Nitros9 using a 51/4 system disk configured to the hardware
> This works perfectly. I copied the system disk to the SDC as NITROS9. DSK. Then connected the SDC and disto board to the coco BUS with a 'Y' cable. When I launch the disk image using 'DOS' it will only boot halfway then fail
>
> Is i‎t because I am using a 'y' cable and the SDC pak? The same setup(with the Y cable) will still boot using the 5 1/4 disk and drive?
>
> Sent from my BlackBerry Passport Red Edition.
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>


--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco


More information about the Coco mailing list