[Coco] Arduino DriveWire server
go4retro at go4retro.com
Sun Jun 19 01:37:06 EDT 2016
On 6/18/2016 11:11 PM, Barry Nelson wrote:
> It can do it, I'm sure to, but only if you change the clock crystal or do raw bit level I/O. If you try to use it as is the baud rates at the higher speed are just ever so slightly off.
That's just a quick 2 pin solder job :-)
But, yes, arduino PCBs would need a clock that is a multiple of
1.8432MHz (I use 14.7456MHz), as it's below the 16MHz limit on most AVRs.
More information about the Coco