[Coco] SDC oddness

Darren A mechacoco at gmail.com
Sun Feb 8 11:50:17 EST 2015


On Sun, Feb 8, 2015 at 9:19 AM, Steven Hirsch wrote:


> 3. The underlying issue is that the SDC board doesn't have a "Tandy"
> standard spacing between the tip of the edge connector and the PCB center
> hole.  So, if Tim relocated the holes in the case design it would put other
> boards that follow the "standard" (such as it is) too far in.
>
> Maybe it's possible to change the SDC board design?  Not sure what the
> best all around answer is.
>


The SDC board dimensions and mounting hole locations are the same as an
FD-502 controller board.
The "Tandy" products do not have a standard spacing.  The FD-501 case,
being the same size on the outside as the FD-502, as different internal
fixture locations.

- Darren


More information about the Coco mailing list