[Coco] CoCo 2 Factory Composite Video RE'd

[Zippster]

From what I’ve read, my understanding is that the CoCo1 did generate a composite signal that could be tapped
before it went to the RF modulator, but that the CoCo2’s used the 1372 differently, going directly to RF
and didn’t have a valid composite signal that could be tapped directly (except for Luma maybe).

I think those CoCo2 “video driver boards" were picking up the various signals and then generating the composite signal.

A clipped in adapter could easily be done, but I’d much rather have something soldered in.

- Ed

> On Dec 15, 2014, at 11:19 AM, Bruce W. Calkins <brucewcalkins at charter.net> wrote:
> 
> Be advised that the modulators are different in the CoCo 1.  For one thing the MC-1372 is on the motherboard and not in the RF modulator.  My CoCo 1 composite monitor driver simply clipped to several points on the motherboard.  FWIW; it looks to me that you have complicated a simple task. "Back in the day" even the CoCo 2 composite monitor drivers simply clipped in, the rub being that the RF modulator needed to be opened to access the MC-1372.
> Bruce W.
> ==================
> 
> 
> ----- Original Message ----- From: "Zippster"
> 
>> I can layout boards to replace any of the RF modulators if I know the dimensions and pinouts.
>> 
>> So far I know of 3 types, CoCo 2 - Korean motherboards (RF lays flat on MB), earlier (pre-Korean?)
>> motherboards where the modulator is larger, and on edge.  And then CoCo1 (all the same modulator?)
>> 
>> I have no problem doing boards for all these types if people want them.
>> 
>> - Ed 
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> http://www.avast.com
> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco