[Coco] miniFLASH product

[Al Hartman]

Nice!

I've been meaning to write you to order one of the last SIMM based 512k Coco 
3 upgrade kits. I have a box full of SIMMs here that should work.

Al

-----Original Message----- 
From: Mark Marlette
Sent: Tuesday, September 10, 2013 3:18 PM
To: CoCo-MaltedList
Subject: [Coco] miniFLASH product

Moved to a different thread.......

Al,

This product will be a direct copy from the sIDE hardware. Might add the 
ability to do 2- 32K ROMs....

The sIDE was released in 2004.

I was going to make a separate product call FLASHpak. Have that in prototype 
form, would save 600+ paks on a single pak.

Decided to integrate that in to the SuperSD design. These ROMS will be 
loaded at boot time. Have this working already, can load a 8K file in ~12mS.

The SuperSD will also have a USB2.0 COM port on it that will run at the 
CoCo's full bandwidth, RAW speeds obtained have been ~100K-110K BYTES per 
second.

The miniFLASH product will offer a much lower entry point, target is ~$40.

Not all want the power tools, that is fine by me as well. I sold my last 
separate disk controllers this past weekend that normally contain HDB-DOS 
boot ROMs. So I needed a solution as well.

Nothing earth shattering or great here, just a slimmed down FLASHpak.

Will let you know when it is ready for release.

Regards,

Mark
http://www.cloud9tech.com

--
Coco mailing list
Coco at maltedmedia.com
http://five.pairlist.net/mailman/listinfo/coco