[Coco] schematic for the CoCo3 to the Sony KV1311CR monitor
Frank Davis
fodavis at hotmail.com
Sat Nov 7 17:50:36 EST 2015
Sent from my Samsung Galaxy TabĀ® S
-------- Original message --------
From: "Theodore (Alex) Evans" <alxevans at concentric.net>
Date: 11/07/2015 13:22 (GMT-06:00)
To: CoCoList for Color Computer Enthusiasts <coco at maltedmedia.com>
Subject: Re: [Coco] schematic for the CoCo3 to the Sony KV1311CR monitor
On 11/06/2015 01:16 AM, Barry Nelson wrote:
> You know instead of requiring a separate +5V supply and a 74LS02 IC, you could probably just connect pin 30 on the monitor input to the center pin of the composite video output on the Color Computer 3. That may even work better because the output from the 74LS02 would lack the front and back porch plateaus that most TV/monitors want to see on the sync signal that helps set the black voltage level. The presence of a video signal on the sync line would probably be ignored. Of course there is only one way to find out how well this would work, try it. The cable I designed for SCART uses this approach, but unfortunately it still requires a +5V source to apply a voltage to one of the SCART pins that tells it that you are sending it an RGB signal. That would not be needed with this sony TV/monitor.
>
Years ago I hacked my CC3 so that I easily connect it to a Commodore
1080 monitor. I put the IC on the inside of the case, connected Vcc and
GND to other chips and ran the output out of the "unused" pin on the RGB
connector on the bottom of the CoCo.
--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco
More information about the Coco
mailing list