[NHRC-user] FW: update on tone encode problem
KD6KPC
kd6kpc at comcast.net
Thu May 17 11:53:17 EDT 2007
Magically, the tone encoder on the new board started working flawlessly.
Will monitor and see what happens next. I'll have to test it again on a hot
day.
Thanks,
- Garrett
-----Original Message-----
From: nhrc-user-bounces at nhrc.net [mailto:nhrc-user-bounces at nhrc.net] On
Behalf Of Jeff Otterson
Sent: Wednesday, May 16, 2007 4:13 PM
To: NHRC User Community Mailing List
Subject: Re: [NHRC-user] FW: update on tone encode problem
Uhhh, could it be a problem with your transmitter exciter?
Typically the encoder tone does not run through the repeater controller.
Regards,
Jeff
At 05:21 PM 5/16/2007, you wrote:
>
>-----Original Message-----
>From: Garrett Dow [mailto:gdowkpc at comcast.net]
>Sent: Wednesday, May 16, 2007 2:19 PM
>To: NHRC-user at nhrc.net
>Subject: update on tone encode problem
>
>
>Update on the tone encoder issue. I swapped out the TS-32 with another
>tone board and the problem is persisting. I have an NHRC-4 controller I
>can use to swap out the NHRC-3, but I don't know if I am headed in the
>right direction. I think I may need to try some alternate tones first.
>
>Does anyone have any ideas which way I should proceed on this issue?
>
>73's
>
>Garrett Dow, KD6KPC
>http://www.nwham.com <http://www.nwham.com/>
>
>_______________________________________________
>NHRC-user mailing list
>NHRC-user at nhrc.net http://five.pairlist.net/mailman/listinfo/nhrc-user
_______________________________________________
NHRC-user mailing list
NHRC-user at nhrc.net http://five.pairlist.net/mailman/listinfo/nhrc-user
More information about the NHRC-user
mailing list