[NHRC-user] TAIL BEEP
JC Weston
jcweston at kingston.net
Fri Jun 1 02:41:05 EDT 2007
Thanks so much for the reply & help Richard...Seems ok now. I assume that
if I put the write protect on everything should stay put.
Cheers...Jack
P.S. I used the *7140505 and put the A4 tone in memory record slot 4 for a
beep when COR drops. Assume that would be correct.
----- Original Message -----
From: "Richard Cox" <rich at nhrc.net>
To: "NHRC User Community Mailing List" <nhrc-user at nhrc.net>
Sent: Thursday, May 31, 2007 10:08 PM
Subject: Re: [NHRC-user] TAIL BEEP
> Jack,
>
> To reprogram the courtesy tone, you first need to unlock the controller.
> Then, following page 27 of the NHRC-5 manual, you would enter: *71<n><ddtt
> ddtt ddtt ddtt> where <n> is the courtesy tone number to play or program.
> The valid range of values is 0 to 7. And <ddtt ddtt ddtt ddtt> is up to
> four
> sets of duration and tone. Duration is in 10 ms increments, valid range
> is
> 01-98. Both digits must be specified. Tone is set from the codes listed
> on
> page 49.
>
> For example, to reprogram the main receiver courtesy tone for a single
> tone
> of A4, for a duration of 50 ms, you would first unlock the controller,
> then
> enter *7100505 - where "*71" is for the courtesy tone program/playback
> code,
> "0" is for the main receiver courtesy tone, "05" is for the 50ms duration
> (in 10ms increments) and "05" is for the A4 tone.
>
> You can play back the courtesy tone to verify that it programmed OK by
> entering *710.
>
> When programming is complete, send # to relock the controller.
>
> Hope this helps.
>
> Regards,
> Richard Cox / N1LTL
> NHRC Repeater Controllers
> http://www.nhrc.net
>
>
>
> -----Original Message-----
> From: nhrc-user-bounces at nhrc.net [mailto:nhrc-user-bounces at nhrc.net]On
> Behalf Of JC Weston
> Sent: Thursday, May 31, 2007 9:02 PM
> To: NHRC-user at nhrc.net
> Subject: [NHRC-user] TAIL BEEP
>
>
> I have recently set up a new NHRC-5 controller on our repeater. Everything
> has gone well except for programing a tail courtesy beep on the main
> repeater. I wish to use the tone described in the manual as tone code 05
> tone A4. I find the manual some what confusing in the area of courtest
> beeps
> and cannot seem to find the proper string to enter in order to change the
> default tail beep.
>
> Thanks all..
> Jack..!!
> _______________________________________________
> NHRC-user mailing list
> NHRC-user at nhrc.net
> http://five.pairlist.net/mailman/listinfo/nhrc-user
>
> _______________________________________________
> NHRC-user mailing list
> NHRC-user at nhrc.net
> http://five.pairlist.net/mailman/listinfo/nhrc-user
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.472 / Virus Database: 269.8.0/818 - Release Date: 5/25/2007
> 12:32 PM
>
>
More information about the NHRC-user
mailing list