[NHRC-user] Wimpy, echo'y ID audio, no bass
Jeff Otterson
jeff at nhrc.net
Mon Feb 6 06:40:48 EST 2006
The receiver input to the NHRC-5 is about 10K ohms impedance.
That would be a good place to start.
Otherwise, you could conceivable wire in to pin 3 of the DAD
connector. You need to have a 1/2 Vcc DC bias here, though. Might be more
trouble than it's worth.
Jeff
At 12:06 AM 2/6/2006, you wrote:
>I have a pre-recorded ID that I am trying to play back form my laptop .WAV
>file. I acoustically coupled a walkie to my laptop speaker to transfer
>the audio ID. Wimpy, echo'y audio, no bass, sounds like how it was
>actually played back.
>
>I also originated wired audio from a mobile (mike hi was all I could get
>my hands on), and that was even worse! Possibly a gross impedance mismatch.
>
>Can I hard wire -10 dBmv unbalanced audio to some point in the NHRC-5 to
>get a genuine, full 300-3K frequency response (ie: aux in, etc) ?
>
>Thanks,
>
>
>____________________________________________
>Rick Zach, K1RJZ
>_______________________________________________
>NHRC-user mailing list
>NHRC-user at nhrc.net
>http://five.pairlist.net/mailman/listinfo/nhrc-user
More information about the NHRC-user
mailing list