[NHRC-user] NHRC-4/M2 Question

[David Shiplett]

NHRC-4/M2...

Jeff,

I was also wrong about the led that I thought was the RB is actually the
main receiver green LED. A couple of other pieces of information. I am
applying a continuous signal on the receiver with a 1khz tone. I am using PL
decode only to access the repeater. I have checked the 10 regulator in it
appears clean. What has me perplexed is the every 4 minute hit on the main
COS and PTT line. Without any corresponding change in the receiver. After
the second hit in a couple of minutes the unit ID's and the cycle starts
over.

Dave

Dave

-----Original Message-----
From: nhrc-user-admin at nhrc.net [mailto:nhrc-user-admin at nhrc.net]On Behalf Of
Jeff Otterson
Sent: Thursday, February 28, 2002 5:58 PM
To: nhrc-user at nhrc.net
Subject: Re: [NHRC-user] NHRC-4/M2 Question

Hi David,
   Which controller are you referring to?

   Jeff Otterson
   NHRC LLC

At 02:15 PM 2/28/2002, you wrote:
>Has anyone had a situation where the NHRC appears to get a reset signal on
a
>periodic reoccurring basis. I am experiencing a problem where we seem to be
>getting an ID every 11  12 minutes. Upon watching the unit I see a false
>signal setting off the RB PTT and the Main PTT every 3 minutes 55 seconds
>give or take a few.
>
>The unit is being operated in PL mode only using a TS-32 so you would thing
>nothing should false the line to reset the timer for CW ID. You may even
get
>a courtesy tone at the PTT event but not always.
>
>Also, what is the difference between rev a and rev b units?
>
>David L. Shiplett
>Warner Robins Operations Manager
>LH Network, Inc.
>211 Independence Drive
>Warner Robins, GA 31088
>email: Daves at lhnetwork.com
>(478) 971-3281 (V)
>(478) 971-3481 (F)
>

_______________________________________________
NHRC-user mailing list
NHRC-user at nhrc.net
http://two.pairlist.net/mailman/listinfo/nhrc-user