[Coco] SDC Startup.cfg Question

[Michael Kline]

Thanks...

I tried it. But, it didn't work. Nothing changed in my drive listings 
for DriveWire.

When I execute it via command line, I'm good. Just can't get the startup 
to comply.


Michael

--


On 11/12/2018 19:13, rietveld rietveld wrote:
> This is my STARTUP.CFG
>
>
> 0=/SDCX.DSK                           this boots SDCX on power up
> 2=#0                                          sets my drivewire
> 3=#0                                          sets my drivewire
>
>
> Hope that this helps
> ------------------------------------------------------------------------
> *From:* Michael Kline <klinems at yahoo.com>
> *Sent:* December 11, 2018 3:40 PM
> *To:* rietveld rietveld
> *Subject:* Re: [Coco] SDC Startup.cfg Question
> Yes, it works through the command line. But, what's the syntax for using
> DRIVE2,#3 in the startup.cfg? (DRIVE2,#3 doesn't work in startup.cfg).
>
>
> On 11/12/2018 13:47, rietveld rietveld wrote:
> > DRIVE 2,#0
> >
> > 0 can be replaced with any number 0-63
> >
> > Sent from my BlackBerry
> >    Original Message
> > From: Michael Kline via Coco
> > Sent: Tuesday, December 11, 2018 1:52 PM
> > To: Coco at maltedmedia.com
> > Reply To: CoCoList for Color Computer Enthusiasts
> > Cc: Michael Kline
> > Subject: [Coco] SDC Startup.cfg Question
> >
> >
> > What is the syntax for assigning DW paths in the SDC for startup.cfg?
> > Like executing DRIVE2,#3 in DECB.
> >
> > Thanks!
> >
> > Michael
> >
> >
> >
> > --
> > Coco mailing list
> > Coco at maltedmedia.com
> > https://pairlist5.pair.net/mailman/listinfo/coco
> >
>