[Coco] Fwd: IP packets on my coco

[Dave Philipsen]

The 8-pin board has two general purpose I/Os on it.

On 6/12/2016 12:06 AM, Brett Gordon wrote:
> And spi is synchronous to the coco right? That sounds like a good thing.
> I've seen where peeps have reprogrammed the soft uart to do rts/cts too -
> given all the pins are there. I wonder what happens when you dont unload
> data fast enough.
>
> Brett M Gordon
> On Jun 11, 2016 7:26 PM, "RETRO Innovations" <go4retro at go4retro.com> wrote:
>
>> On 6/11/2016 4:31 PM, Tormod Volden wrote:
>>
>>> I have some experience with the stock ESP8266 as I was hooking it up
>>> via my uDW DriveWire microserver, but I didn't get much further than
>>> "hello internet" before the DriveWire virtual channels I was using
>>> became "delicate" and I haven't gotten back to this. From a quick
>>> investigation on my ESP8266 modules I don't think the pins available
>>> (these are the modules with 8 pins) can be used for SPI.
>>>
>> The versions I am looking at are the ESP-12e and the ESP13, which have 20+
>> pins.
>>
>> Jim
>>
>>
>> --
>> RETRO Innovations, Contemporary Gear for Classic Systems
>> www.go4retro.com
>> store.go4retro.com
>>
>>
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
>>