[Coco] Mounting of FPGA analog board?

[Zippster]

No, you’ll need a new programming file.  

Gary has issued a new release on the Yahoo group.

- Ed


> On Aug 7, 2016, at 2:17 PM, Steven Hirsch <snhirsch at gmail.com> wrote:
> 
> On Sun, 7 Aug 2016, Zippster wrote:
> 
>> Hi Steven,
>> 
>> It’s a complete set of hardware (except for the rubber feet).  Just in case.  :)
> 
> Hi, Ed.
> 
> You are nothing if not thorough!  :-)
> 
> I think I know the answer to this, but will a DE-1 loaded with a pre-analog board bitstream boot and run with the board attached?
> 
> Mine will sometimes show the easter-egg graphic, but never the boot screen.  I'm hoping it's just a matter of the old bitstream not liking the extra hardware.
> 
> 
> 
> 
>>> On Aug 7, 2016, at 9:41 AM, Steven Hirsch <snhirsch at gmail.com> wrote:
>>> I have finally found time to sit down and install Ed's analog board.  I'm scratching my head over the included hardware.  There are three different lengths of spacer and about 12 screws in the kit, but I cannot see why I'd need more than
>>> 2 x long spacer
>>> 2 x medium spacer
>>> 4 x screws
>>> What is the rest of the hardware for?
>> 
>> 
>> -- 
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
> 
> -- 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco