[Coco] Run of RGB2VGA boards

[Zippster]

Super easy, there is ground plane right next to Pin 10.  Just scrape away
a little solder mask on the bottom of the board next to the pin and create a
solder bridge.

Detail of connector area...
<https://drive.google.com/open?id=0B1sgl615FlGnODZOSVJnVjZLbGs <https://drive.google.com/open?id=0B1sgl615FlGnODZOSVJnVjZLbGs>>

The red traces for the sync lines are on the top layer of the board, so you’re
clear on the bottom (blue).

- Ed


> On Sep 12, 2015, at 10:31 AM, Brett Gordon <beretta42 at gmail.com> wrote:
> 
> ok... Im guessing it wouldn't be hard for a guy with a soldering iron to
> connect pin 10 to ground?
> On Sep 12, 2015 11:26 AM, "Zippster" <zippster278 at gmail.com> wrote:
> 
>> No, only R, G, B, HSYNC, and VSYNC are brought through the connector to
>> the board.
>> 
>> - Ed
>> 
>> 
>>> On Sep 11, 2015, at 11:47 PM, Brett Gordon <beretta42 at gmail.com> wrote:
>>> 
>>> Does the RGB2VGA board support the coco's monitor detect line?
>>> 
>>> --
>>> Coco mailing list
>>> Coco at maltedmedia.com
>>> https://pairlist5.pair.net/mailman/listinfo/coco
>> 
>> 
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
>> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco