[Coco] Coco Costing

Michael Brant brant.michael.l at gmail.com
Mon Mar 16 23:50:36 EDT 2015


thanks, I had expressed interest, however, if it is compatible with the
CoCo2 and 3, I might be interested in at least 2 MPIs.   I hope this helps
in determining your production count.

On Mon, Mar 16, 2015 at 11:46 PM, RETRO Innovations <go4retro at go4retro.com>
wrote:

> On 3/16/2015 10:30 PM, Michael Brant wrote:
>
>> It seems it has been a while since this thread was discussed. But I have
>> two questions.  Would this MPI be usable on just the CoCo3 or on early
>> CoCo
>> models?
>>
> It should work on both just fine, but if you wanted the higher addressed
> (ff80+), then it would need a new CPLD programmed.
>
>> And did you come to a final estimate on the cost?
>>
> Not yet.  Board costs were lower than I anticipated, but I was waiting on
> a cart case to scope for measurements, do the final board render, and then
> get a final cost.
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>


More information about the Coco mailing list