[Coco] 4 Port MPI PCB artwork (so far)

[Joe Grubbs]

Awesome! Well I would be very interested in obtaining one of these when the final design is done. I'd be happy with 4 or 8 slots. Anything more than just 1 :)

--- Original Message ---

From: "RETRO Innovations" <go4retro at go4retro.com>
Sent: March 2, 2015 5:06 AM
To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
Subject: Re: [Coco] 4 Port MPI PCB artwork (so far)

On 3/2/2015 3:31 AM, Joe Grubbs wrote:
> Great work Jim.
>
> I sort of became a bit lost in the MPI debacle, but is this a design you intend to produce and sell?
I'll put something in the store, but not sure if it'll be this 4 porter
or an 8 porter.  The 8 porter is just this unit... stretched, basically,
so I figure I'll get his one done (correct size PCB, the cabling to
detach, etc.), and then run a small batch of boards and hand solder a
few for folks to test.

I am trying to see if there might be a way to put 1 conn at the end
horizontal, 2 underneath, horizontal, and one off the side, to get 8
ports without the bulk/length.  Not sure, but figured can't hurt to try.

Jim


--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco