[Coco] Mutlipak Potetnial to Fry CPU

[Bruce W. Calkins]

I have seen the dimensions published somewhere.  As to if it was in one of 
the magazines or on-line I don't remember.

Bruce W.

==================



----- Original Message ----- 

From: "Josh Harper via Coco"

> id like one of those plates  if anyone has one for sale  or has the 
> measurements for it let me know thanks
> ________________________________
> From: "jmlaw at iprimus.com.au"

>
> On 11/10/2014 10:27 AM, S Klammer wrote:
> But for those who do, there was a plate I saw advertised once in Rainbow 
> (I
> think) that went around the two right CoCo feet and the feet of the
> mutli-pak so the two can't be pulled apart without lifting them. Picture a
> plate with 6 holes lineed up with those feet. Something similar made from
> Masonite or 3mm MDF if done right could be easier to make than a steel 
> plate
> to reduce the risk. Or if someone has access to a plasma cutter, maybe a
> product they could offer.
>
> Again, just putting it out there should someone be able to make use of it.
> Though I'm sure many would be aware of it or come up with an alternate
> solution.
>
> Jason


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com