[Coco] MPI help needed

tonym tonym at compusource.net
Tue Jun 10 23:28:01 EDT 2014


Tried what you said before, rompak in slot 3, switch set to 1.
type poke &HFF7F,&H22, and the ROMPAK immediately fired up (Mega Bugs)

Just to clarify, no matter WHAT slot # the switch is set to, ROMpak works in slot 1.
And does not work in the slot the switch is set to.

Tony
tonym at compusource.net


---- Original Message ----
From: "Arthur Flexser" <flexser at fiu.edu>
Sent: 6/10/2014 11:12:13 PM
To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
Subject: Re: [Coco] MPI help needed

Another possibility is that the autostart has been deliberately or
accidentally disabled on slots other than 1.  You could try setting the
switch to a slot other than the one that works, putting a rompak in that
slot, and then trying EXEC&HE010 to see if that starts up the rompak.

Art


On Tue, Jun 10, 2014 at 10:47 PM, tonym <tonym at compusource.net> wrote:

> OK gents...
>
> Need an assist... Pulled out an old grey -3024 (not yet modified) out of
> the mothballs.
> Plugged it in, into a coco3. Can't get anything but slot 1 to work, no
> matter WHAT slot the switch is on.
>
> Using a rompak, tried all 4 slot, using their respective switch position,
> only slot 1 worked.
>
> Putting switch on slot 2, pak works in slot 1, same thing for switch to
> slot 3, slot 1 works, same with switch set to slot 4, slot 1 works.
>
> Any ideas?
>
> Tony
> tonym at compusource.net
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
>

-- 
Coco mailing list
Coco at maltedmedia.com
http://five.pairlist.net/mailman/listinfo/coco




More information about the Coco mailing list