[Coco] MPI help needed

[Bill Nobel]

wasn’t there a software switch if I remember?

Bill Nobel

On Jun 10, 2014, at 9:01 PM, tonym <tonym at compusource.net> wrote:

> First thing I was thinking.... But I wasn't sure if it lead to some logic that did the actual switching...
> 
> Tony
> tonym at compusource.net
> 
> 
> ---- Original Message ----
> From: "Bill Nobel" <b_nobel at hotmail.com>
> Sent: 6/10/2014 10:59:24 PM
> To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
> Subject: Re: [Coco] MPI help needed
> 
> That would suggest the switch itself to me, as the slot doesn’t seem to switch.
> 
> Bill Nobel
> 
> On Jun 10, 2014, at 8:47 PM, tonym <tonym at compusource.net> wrote:
> 
>> OK gents...
>> 
>> Need an assist... Pulled out an old grey -3024 (not yet modified) out of the mothballs.
>> Plugged it in, into a coco3. Can't get anything but slot 1 to work, no matter WHAT slot the switch is on.
>> 
>> Using a rompak, tried all 4 slot, using their respective switch position, only slot 1 worked.
>> 
>> Putting switch on slot 2, pak works in slot 1, same thing for switch to slot 3, slot 1 works, same with switch set to slot 4, slot 1 works.
>> 
>> Any ideas?
>> 
>> Tony
>> tonym at compusource.net
>> 
>> -- 
>> Coco mailing list
>> Coco at maltedmedia.com
>> http://five.pairlist.net/mailman/listinfo/coco
>> 
> 
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
> 
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco