[Coco] [coco] Coco CNC

[George Ramsower]

http://coco.thetinbox.com/NewMillPageTwo.html

Got the working table on it now

Tonight, I mounted a piece of aluminum stock to it and I am now facing the 
surface to see if the mill will do this properly. If the dremmel is 
vertical, and the slides are parrallel, then I should get a good finish on 
the part. Won't know until it's done.... this takes some time.

Then I have to face the part 180 degrees differently to see if the other 
perpendicular is right.

 So much to do, so little time.

George