[Coco] 2764 EPROM

Joef6809 joef6809 at gmail.com
Mon Sep 10 03:26:04 EDT 2007


I was actually thinking more like this.
http://vcc6809.bravehost.com/Pics/ide.html
Some hand work would be needed to get the final shape but I think it will 
work out well.
I figure at worst I'll waist $60.00

----- Original Message ----- 
From: "Darren A." <darccml at hotmail.com>
To: <coco at maltedmedia.com>
Sent: Monday, September 10, 2007 2:22 AM
Subject: Re: [Coco] 2764 EPROM


> >From: "Joef6809"
>>Subject: Re: [Coco] 2764 EPROM
>>Date: Sun, 9 Sep 2007 22:39:07 -0400
>>
>>Theres a company call expresspcb that will etch 3 2.5 x 3.8 Inch board for
>>$51.00 + $8.00 shipping.
>>Pretty much the perfect size to fit in a standard Rom pack. They even have
>>free schematic and design software.
>>I'm using it to try to build a glenside IDE controller plus CF card into a
>>single pack.
>>anyway look at http://www.expresspcb.com/ and check out there MiniBoard
>>service.
>>
> -
>
> If the width of their MiniBoard was 0.4 inches smaller it *would* be the
> perfect size for a ROM pack. If you use these boards you will need to trim
> it to fit the CoCo's 40 pin socket which is 2.1 inches wide.
>
> _________________________________________________________________
> Gear up for Halo® 3 with free downloads and an exclusive offer.
> http://gethalo3gear.com?ocid=SeptemberWLHalo3_MSNHMTxt_1
>
>


--------------------------------------------------------------------------------


>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
> 




More information about the Coco mailing list