[Coco] Sort of OT: Recapping

Gene Heskett gheskett at shentel.net
Sun Nov 29 20:21:21 EST 2020


On Sunday 29 November 2020 18:45:39 Salvador Garcia via Coco wrote:

>  Update:
> First, thank you all for your advice and recommendations.
> I finally got all the through holes clear of solder and stuck leads. I
> heated the Weller station to 850F. I noticed that at times it spiked
> to 880F. Somewhere between these two temperatures the solder melted
> and the solder and stuck leads came out without any problems. I
> replaced the caps. I will now get some flux remover and clean the PCB
> and test. Hopefully the MB will still work :-S. I am usually confident
> with my work, but I have to admit that the PCB took a lot of heat. I
> am hoping 0 damage. Again, thanks for your help. I will properly
> document this experience. Salvador

For flux removal, nothing in my looooooong experience beats plain old 
hardware store, paint shelf aisle, acetone and Q-tips. But don't ever 
reuse the Q-tip, cuz that will contaminate the acetone, ditch it in the 
round can under the bench and get another to wet and go after some more 
flux, its not like they are expensive.  Get your q-tips from the 
pharmacy, brand Sherwood Medical, one ended wooden sticks about 7 or 8" 
long, gives you a long enough handle to do it right. Somewhere around a 
tenner for 1000 of them in paper bags of 100, 10 bags to the carton. No 
ignition sources around the open can, or the waste can as its quite 
inflammable.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


More information about the Coco mailing list