[Coco] Writing a virtual GPU / FPU device.
L. Curtis Boyle
curtisboyle at sasktel.net
Fri May 31 05:54:11 EDT 2019
That should say “Glenside”.
Sent from my iPhone
> On May 30, 2019, at 11:32 PM, L. Curtis Boyle <curtisboyle at sasktel.net> wrote:
>
> I can confirm that the angle side IDE has a jumper between FF50 and FF70.
>
> Sent from my iPhone
>
>>> On May 30, 2019, at 10:49 PM, RETRO Innovations <go4retro at go4retro.com> wrote:
>>>
>>> On 5/30/2019 10:42 PM, Bill Nobel wrote:
>>> Although it’s not complete, but thanks Jim. I was looking for the same type of thing. I do have a question though. You have blue as Alternate Primary, is this a ghost image of the device? I.E. if I Poke to $FF50 for the Glenside does the same value appear at $FF70?
>>
>> No, I understood those devices have a jumper or some configuration setting to "move" the base address.
>>
>> The addresses you would note as "ghost image" I note in the spreadsheet as "mirrored address", I think.
>>
>>
>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> https://pairlist5.pair.net/mailman/listinfo/coco
>>
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>
More information about the Coco
mailing list