[Coco] Looking for source to Multiview Line Drawing Demo
Walter
zambotti at iinet.net.au
Sun Jun 2 00:06:41 EDT 2019
Robert
I have dump'd the program and then run it through disasm but that only reveals the module header.
All the assembler is simply fcb and fdb hex. Which means disassembly by hand.
Maybe I'm using the wrong disassembler!
Walter
-----Original Message-----
From: Coco [mailto:coco-bounces at maltedmedia.com] On Behalf Of Robert Gault
Sent: Thursday, 30 May 2019 2:09 AM
To: CoCoList for Color Computer Enthusiasts
Subject: Re: [Coco] Looking for source to Multiview Line Drawing Demo
Walter,
Based on the Nitros9 project not having real .asm files for Demo and that the Multi-Vue zip file in
the http://www.colorcomputerarchive.com/coco/Disks/Operating%20Systems/ does not have the source
code, it looks like you will need to disassemble the program.
Far as I can see after a disassembly, the program is not in C language even though most of the
references in the MV owner's manual are in a chapter on "C Language Graphics Library Support".
So, "dump" demo to get all the asci comments and then disassemble it. It should not be very hard to
correct the disassembly with the dump info.
Robert
Walter Zambotti wrote:
> Was wondering if the source for Multiview line drawing demo was available
> anywhere?
>
>
>
> Walter
>
>
--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco
More information about the Coco
mailing list