[Coco] VCC 2.0.2 with full 6309 emulation. Runs Nitros9 EOU 6309.

[Bill Pierce]

Salvador, If all you had was the Coco3.rom, then that's why it crashed LOL
It also needs the disk11.rom and the orch90.rom (if the cart is to be mounted)
When you insert these dlls into the slot, the roms for the pak are loaded. It couldn't load disk11.rom, so it crashed.

The only roms needed for VCC to run are:
Vcc.exe - coco3.rom
fd502.dll - disk11.rom rgbdos.rom-(only if checked in fd502 config)
orch90.dll - orch90.rom

All other roms are optional, like RGBDOS.rom, HDBDOS.rom, etc, but these need to be in the install dir if you use them.
 
 
 
-----Original Message-----
From: Salvador Garcia via Coco <coco at maltedmedia.com>
To: Bill Pierce via Coco <coco at maltedmedia.com>
Cc: Salvador Garcia <salvadorgarciav at yahoo.com>
Sent: Thu, Dec 5, 2019 2:37 pm
Subject: Re: [Coco] VCC 2.0.2 with full 6309 emulation. Runs Nitros9 EOU 6309.

 Thanks Bill,

I have the coco3.rom file which is the only file that VCC asked for when I first tried to run it.

Perhaps I went about all wrong. Instead of just unzipping the download file's contents and running VCC.exe, I should have first downloaded the previous version, ran the install program and when I had that working I should have replaced the existing file with these pertaining to v 2.0.2.

Perhaps I incorrectly assumed that I could just extract and run VCC.exe for 2.0.2.

Salvador


    On Wednesday, December 4, 2019, 10:56:29 PM CST, Bill Pierce via Coco <coco at maltedmedia.com> wrote:  
 
 Salvador, did you have the roms in your VCC installation dir?
 
 
 
-----Original Message-----
From: Salvador Garcia via Coco <coco at maltedmedia.com>
To: CoCoList for Color Computer Enthusiasts <coco at maltedmedia.com>
<snipped>
  

-- 
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco