[Coco] 3D printer and PI

[Walter Miraglia]

Octopi is a terrific interface for controlling and sending print jobs to
your 3d Printer.
i use it on two of my printers. :) very cool indeed. :)

On Wed, Jul 19, 2017 at 7:03 PM, Rietveld Rietveld <rietveldh at hotmail.com>
wrote:

> Just thought I would mention it since a lot of guys here are using a PI.
>
> Sent from my BlackBerry Passport Red Edition.
>   Original Message
> From: Dave Philipsen
> Sent: Wednesday, July 19, 2017 7:00 PM
> To: CoCoList for Color Computer Enthusiasts
> Reply To: CoCoList for Color Computer Enthusiasts
> Subject: Re: [Coco] 3D printer and PI
>
>
> Very cool!  Thanks for sharing.
>
> Dave
>
> > On Jul 19, 2017, at 5:21 PM, Rietveld Rietveld <rietveldh at hotmail.com>
> wrote:
> >
> > Not sure if anyone else finds this cool, but I do
> >
> > I turned my 3D printer into a stand alone
> >
> > I mounted a PI inside of it. I can wirelessly access it from any device
> and load prints to it from my phone or laptop
> > I can even remotely heat up the printer
> > I installed a PI camera so I can remotely view the printing while I am
> away by port forwarding to view it with my phone
> >
> >
> >
> > Sent from my BlackBerry Passport Red Edition.
> > <IMG_20170719_1801296.jpg>
> >
> > --
> > Coco mailing list
> > Coco at maltedmedia.com
> > https://pairlist5.pair.net/mailman/listinfo/coco
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>