[Coco] ROM Cart registers

Mark Marlette mmarlette at frontiernet.net
Mon Feb 1 17:59:01 EST 2016


Jim,
Move them as you need to.
Regards,
Mark Marlette
 http://www.cloud9tech.com
mark at cloud9tech.com
 

      From: RETRO Innovations <go4retro at go4retro.com>
 To: CoCoList for Color Computer Enthusiasts <coco at maltedmedia.com> 
 Sent: Monday, February 1, 2016 4:55 PM
 Subject: Re: [Coco] ROM Cart registers
   
  As noted in my response to Darren just now, I latched SCS~ and then
  asserted SLENB in a test to see if I could get my device to slide
  everything off the bus (I understand the sIDE is there, but I was
  assuming it would not be, since its slot was not selected.)

  I do see that Glenside is fully decoded.  That is unfortunate, as that
  means that the MPI available SCS~ space is effectively been halved in a
  system that uses an IDE controller.  Only $ff4x is available in the
  SCS~ space.

  And, it decodes the entire $ff5x space (it appears to repeat the latch
  byte for 8 bytes, as does sIDE to emulate it.)

  Are the registers for the Gen3 Virtual ROM pack in a specific spot (so
  I don't step on those address if I move them?)

  Jim

-- 
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco


  


More information about the Coco mailing list