[Coco] 4 Port MPI PCB artwork (so far)

RETRO Innovations go4retro at go4retro.com
Mon Mar 2 05:05:40 EST 2015


On 3/2/2015 3:31 AM, Joe Grubbs wrote:
> Great work Jim.
>
> I sort of became a bit lost in the MPI debacle, but is this a design you intend to produce and sell?
I'll put something in the store, but not sure if it'll be this 4 porter 
or an 8 porter.  The 8 porter is just this unit... stretched, basically, 
so I figure I'll get his one done (correct size PCB, the cabling to 
detach, etc.), and then run a small batch of boards and hand solder a 
few for folks to test.

I am trying to see if there might be a way to put 1 conn at the end 
horizontal, 2 underneath, horizontal, and one off the side, to get 8 
ports without the bulk/length.  Not sure, but figured can't hurt to try.

Jim



More information about the Coco mailing list