[Coco] using PTC-64 Printer Controller with CoCo

[Camillus Blockx]

Hi chris

You can do an serial to parallel interface, or implement the parallel
interface mod that was in distifano' key of the screw..( I think it
was called ) see the rainbows, or in the archeive.

cb

On Tue, Aug 25, 2015 at 11:17 AM, Chris Oliver <chris.w.oliver at me.com> wrote:
> All,
>
> The Printer Controller has only a standard parallel port:
>
> http://www.radioshackcatalogs.com/html/catalogs_extra/1984_rsc-10/hr036.html <http://www.radioshackcatalogs.com/html/catalogs_extra/1984_rsc-10/hr036.html>
>
> https://archive.org/stream/PTC-64_Printer_Controller_Operation_Manual_1984_Tandy#page/n3/mode/2up <https://archive.org/stream/PTC-64_Printer_Controller_Operation_Manual_1984_Tandy#page/n3/mode/2up>
>
> Is there any way through cabling and/or an adapter/converter of some kind to link the PTC-64 to the CoCo’s onboard serial port?
>
> Thank you!
>
> Chris
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco