[Coco] assembly question

[camillus]

I would try this piece of code in Z-bug or other debugger.
Then you can really follow which registers hold what and the change of CC register.

Unfortunately my coco3 is in ICU, for quit a bit of time now. Hope that changes soon ... lol

cb 

Sent from Mailbird [http://www.getmailbird.com/?utm_source=Mailbird&utm_medium=email&utm_campaign=sent-from-mailbird]
On 8/9/2015 6:25:26 PM, K. Pruitt <pruittk at roadrunner.com> wrote:

----- Original Message -----
From: "camillus"
Sent: Sunday, August 09, 2015 1:30 PM
Subject: Re: [Coco] assembly question


> hi my $0.02 worth.
>
> I looked up in the 6809 instructions and DEC B (A) does not change the
> carrybit.
>
> Also the BCC and/or BGE are testing the carry bit, not the value of the
> counter in B.
>
> BCC ( Branch if Carry Clear ) will only branch when the carry is 0.
>
> BGE ( Branch Greater or Equal to zero ) which will always branch because
> it is either 1 ( greater then 0 ) or 0 ( equal with zero )
>
> So to make this work I would test the content in B with COMB, #0 which
> will set carrybit when true and then BNE ( Branch Not Equal to zero ) as
> next instruction, ofcource needs to branch out of the loop in this case.
> So if you really want to have 4 itterations 0-3 then you have to start at
> 4 because zero would take u out.
>
> The reason that you exit the loop, I think is because the counter B goes
> down to zero, and I do not know if it can go negative. My guess is that
> somehow the carry get set by the fact B try's to go lower then zero.
>
> Do not take this info as the holy grail, it was just my thoughts, and I am
> just human, prone to error or mistakes...lol
>
>
>
> cb
>

Yeah, I suggested the starting at 4 thing as well. You'll have to ask Barry
if he rolled his eyes at my suggestion or not. Hehe.

Internally the MPI's slot are numbered 0-3 and the value in B must follow
the pattern of 3, 2, 1 and 0. If you start at 4 then the CoCo thinks you're
telling it to access slot 5 of the MPI. I even rewrote the routine to run 2
different counters... one for the loop and one to keep track of the MPI
slot. It was absurd. Wasted about 45 minutes on it.

The code initially had a BNE in place of the BGE. It looked like it should
work, but in reality it never included zero in the loop as it bailed AT
zero. And since zero corresponds to slot 1 of the MPI, if you had your
CoCoSDC in slot 1 then the sdir, sdc and sdrive commands reported that it
couldn't find the CoCoSDC.

Barry suggested to me that BCC should work, and I agreed that it should. But
it didn't work for me, so I tried the BGE instruction and it worked.

Here is how I thought the BCC worked in this case: I thought that when the
number went negative it would set the carry flag, thus allowing the loop to
end. As it doesn't set the carry flag it was the wrong instruction for the
task.

BGE fits the logic of the loop and everything seems to work just fine in all
4 slots of the MPI now.



--
Coco mailing list
Coco at maltedmedia.com
https://pairlist5.pair.net/mailman/listinfo/coco


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus