[Coco] any source of 2x20 edge connector for the coco 2 or 3 ?

[Didier Derny]

I was not looking exactly for this connector but I found it on mouser

thanks

On 06/10/2014 03:21, Chad H wrote:
> Kandur, I noticed the soldering you did from the ribbon cable end to the
> card edge :/
>
> A revision to this could take the card edge to a row of holes that would
> allow you to strip the very end of the cable, push it in, and solder
> cleanly.   Or perhaps a location designed to house a 40-pin socket that you
> could just plug the cable into?
>
> -----Original Message-----
> From: Coco [mailto:coco-bounces at maltedmedia.com] On Behalf Of Kandur
> Sent: Monday, October 06, 2014 2:46 PM
> To: CoCoList for Color Computer Enthusiasts
> Subject: Re: [Coco] any source of 2x20 edge connector for the coco 2 or 3 ?
>
> Sorry, those were purchased for another project, this is the one you are
> looking for:
> http://tinyurl.com/kgv4jhf
>
> Kandur
>
> Monday, October 6, 2014, 12:29:28 PM, you wrote:
>> I bought these, $6.59 for 10
>> 10 PIECES OF FEMALE 40 PIN IDC FLAT RIBBON CONNECTOR
>> http://tinyurl.com/nu4ud3j
>
>> Kandur
>> Monday, October 6, 2014, 12:21:16 PM, you wrote:
>>> any source of 2x20 edge connector for the coco 2 or 3 ?
>>> To use with this product:
>>> https://www.oshpark.com/shared_projects/UGHgHdKm
>
>>> it is obvious that a prototype cartridge would be better...
>>> thanks
>>> --
>>> didier
> --
> Coco mailing list
> Coco at maltedmedia.com
> https://pairlist5.pair.net/mailman/listinfo/coco
>
>