[Coco] Powered Y-cable and Super Board

[Kandur]

Luis, the LR-Tech Super Board has no HD controller on it.
http://qdv.pw/eng/_photos/Computers/Coco/cartridges/LR%20Tech%20Super%20Board_8639.jpg 
It has a 6821 PIA parallel (printer), and two 6850 ACIA serial ports,
along with an HD1468 realtime clock. 
I need to set and read the time of the clock from NitrOS-9.

Kandur

Monday, August 4, 2014, 1:50:34 PM, you wrote:
> Well actually it does there is a CHS flags on it. But you must change the
> settings and recompile hdb-dos.

> As I don't have a hard disk I cannot help more than that. You choose
> between LBA and CHS mode AFAIK.



> Luis Felipe Antoniosi




> On Mon, Aug 4, 2014 at 4:42 PM, Kandur <k at qdv.pw> wrote:

>> Downloaded the sources, snapshots and the docs of the Toolshed project.
>> http://sourceforge.net/p/toolshed/wiki/Documentation/
>> Don't seem to find any reference to the LR-Tech Super board.

>> Kandur

>> Monday, August 4, 2014, 10:31:23 AM, you wrote:
>> > Kandur wrote:
>> >> Greetings,
>> >> 1) Looking for a powered Y-cable, or it's construction article, for the
>> Coco-3.
>> >> 2) Anyone happen to have the driver for the LR-Tech Super Board?
>> >>
>> http://qdv.pw/eng/_photos/Computers/Coco/cartridges/LR%20Tech%20Super%20Board_8639.jpg

>> >> Kandur


>> > HDBDOS supports LR-Tech. You can look in the Toolshed project.

>> --
>> Coco mailing list
>> Coco at maltedmedia.com
>> http://five.pairlist.net/mailman/listinfo/coco