[Coco] Blank EPROM-based Program Pak Board Design Released

[Mark J. Blair]

On Nov 4, 2013, at 20:45 , Chad H <chadbh74 at hotmail.com> wrote:
> I think I'm already getting the 'essence' of how to go about it... You start
> with (or edit) a schematic and it turns that into a board design (which you
> can also edit too) and then the project gets exported to 'Gerber' files for
> production?   Are these 'Gerber' files what you had to submit to OSHPark or
> the entire project?

Gerber files are the usual output submitted to PCB manufacturers, but with OSH Park you can just submit the Eagle .brd file. That makes it quite a bit easier.


-- 
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/