[Coco] floppy drive question - only a little OT
Bob Devries
devries.bob at gmail.com
Thu Jul 18 21:36:55 EDT 2013
Robert,
The 1000 HX supplies +12v and +5v one some pins that are *normally* ground
pins. I can't remember exactly which pins, but IIRC it was fairly easy to
determine by looking at the PCB of the drive near the cable connector.
Regards, Bob Devries
Dalby, QLD, Australia
----- Original Message -----
From: "Robert Hermanek" <rhermanek at centurytel.net>
To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
Sent: Friday, July 19, 2013 11:28 AM
Subject: [Coco] floppy drive question - only a little OT
> Since my recent success with 3.5" on my coco3 (thank you everyone) I
> decided to open up my Tandy 1000 HX and see what kind of floppy it has. I
> know it is a standard 720k floppy in terms of software, but when I looked
> in the case I've got this: what appears to be a perfectly normal floppy
> drive, with 34 pin cable attached, and no power cable on the 4 pin power
> connector. Floppy works fine of course -- is it an option I was unaware
> of for floppy drives to receive power via the 34 pin ribbon cable itself?
> I was going to stick a second drive in there, but there is no 4 pin power
> cable available...
>
> Just a little mystery.
>
> -RobertH
>
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
More information about the Coco
mailing list