[Coco] Disk Controllers
billg999 at cs.uofs.edu
billg999 at cs.uofs.edu
Sun Dec 22 16:02:31 EST 2013
> One of the prominent differences is that the 3022 controller requires
> 12vdc
> besides the usual 5vd power, only the CoCo 1 and the MultiPak interface
> provide such, so out of the box this controller can not be used on a CoCo
> 2
> or 3.
Yeah, I had seen that somewhere on the net. Luckily I have two MPI's
for my two 3022's.
> Then there are the other technical subtleties. You can read more
> about this on:
>
> http://www.cocopedia.com/wiki/index.php/26-3022
> http://www.cocopedia.com/wiki/index.php/FD-502_%2826-3133%29
I had seen these, too, but was looking for something more technical,
I guess.
Now, let me throw out two more questions for the experts here.
If I wanted to replace the ROM in the FD-502 with one that had HDB and
drivewire for use on a COCO-2 with a Glenside IDE, which image should I
use?
And now, the big one. Is the controller used in any of these carts
able to do 8" drives? Yes, I know the wiring is different but I have
a couple of these cute little cards that let you hook 8" drives up to
the floppy connector on a PC. That means the it takes care of the
different pin locations and the extra 16 pins. The question is can
the controller handle it?
bill
More information about the Coco
mailing list