[Coco] eprom programmer
Chad H
chadbh74 at hotmail.com
Sat Mar 24 12:49:16 EDT 2012
Hmm...so let me see if my thinking is correct here...
I currently have a 8K 2764 EPROM in my 502 Controller... If I replaced this
with a 27128 16K chip I could combine 2 .ROM files, write them, but I would
be stuck on either the low or high bank.
Now Darren said the high address line was tied to Vcc on the controller.
What if I removed that and ran the Vcc to a switch along with ground and
used the switch to flip Vcc/Ground on the high address pin... Would this
achieve the bank switching effect?
-----Original Message-----
From: coco-bounces at maltedmedia.com [mailto:coco-bounces at maltedmedia.com] On
Behalf Of gene heskett
Sent: Saturday, March 24, 2012 10:54 AM
To: coco at maltedmedia.com
Subject: Re: [Coco] eprom programmer
On Saturday, March 24, 2012 11:53:37 AM Chad H did opine:
> Is this how you would switch banks in the chip too?
>
Yes.
Cheers, Gene
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
My web page: <http://coyoteden.dyndns-free.com:85/gene>
There are never any bugs you haven't found yet.
--
Coco mailing list
Coco at maltedmedia.com
http://five.pairlist.net/mailman/listinfo/coco
More information about the Coco
mailing list