[Coco] Reading coco flash cards or hard disks from a PC

[Joe F]

Hey someone used it! Horray. I still need to add things like 7/8 bit stop
and parity incase your not printing from basic. Just a thought I had, no
timetable for it or anything but Emulating a DMP-105 and outputing to a BMP
file. I'm thinking the 105 as it was a fairly common (cheap) printer at the
time and most software should support its graphics set.

On Fri, May 7, 2010 at 8:14 AM, Brian Blake <random.rodder at gmail.com> wrote:

> You have go into the FD-502 settings and configure the OS to RGB-DOS. Do a
> Hard Reset,  then type DOS 255 to boot the NitrOS-9 version.
>
> BTW, II REALLY like the addition of the Bit-Banger support. Works great for
> printing Basic listings to a txt file for printing. Great work!!!
>
>
>
> On Fri, May 7, 2010 at 7:51 AM, Steven Hirsch <snhirsch at gmail.com> wrote:
>
> > On Wed, 5 May 2010, Joe wrote:
> >
> >  Sorry for the delay here is the link
> >> http://vcc6809.bravehost.com/downloads.html
> >>
> >
> >
> > Dumb question:  How do I get Vcc to boot that OS-9 disk image?  I
> attached
> > it to the hard disk controller and set the virtual MPI to slot 3.  At
> > startup, it just comes up in a modified BASIC screen.  Typing 'DOS'
> yields
> > an error message after a short burst of "disk" activity.
> >
> > Steve
> >
> >
> > --
> >
> > --
> > Coco mailing list
> > Coco at maltedmedia.com
> > http://five.pairlist.net/mailman/listinfo/coco
> >
>
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
>