[Coco] NitrOS-9 sc6551 driver
Roger Taylor
operator at coco3.com
Fri Apr 3 16:25:32 EDT 2009
At 01:33 PM 4/3/2009, you wrote:
> >If you absolutely need CTS/RTS, from the pak's command
> >prompt > type: set flow hardware
> >This will persist until you do a hard reset (while powering up), or
> >typing >set flow none
>
>But I don't have the command prompt anymore. The eprom was pulled
>while I was
>hacking the cs address. So this will have to be done from a program
>I'll have
>to write, and which is not yet written.
SuperComm? I recall a few other OS-9 terminal programs that should work?
Try this as well, but you'll first have to kill the bluetooth
connection from the PC.
echo set baud 19200 >/t2
xmode /t2 bau=7
That should get you rolling at 19200 bps but then you'll have to save
the /t2 config, ofcourse.
> >Gene, I'm so glad you were able to get the wireless pak working under
> >your Linux and CoCo setup! For those who are spot reading this and
> >are confused, Gene basically has a Lot of stuff connected and my pak
> >conflicted with a Tandy pak he didn't want to remove. So he slid the
> >addressing down a few double words by soldering a few wires on the
> >pak board. Now that's a determined CoCoNut. :)
>
>Now who is calling whom a nut? :) Guilty...
haha
--
Roger Taylor
http://www.wordofthedayonline.com
More information about the Coco
mailing list