[Coco] Re: Look what's on eBay / CGP-115 split gears

[Stan Blazejewski]

I tried a simple fix that worked & has lasted for years on a number of these
printers.
The gears split because they are a press fit.  When removed from the shaft you
will notice that the split 'disappears' so I drilled out the hole in the gear so
that it was an 'interference' fit (slides on with no slack & won't grip the
shaft), roughed up the shaft a bit & glued on the gear with super glue.
Works a treat & will never give problems again.

On Tue, 10 Oct 2006 18:21:32 -0400, you wrote:

>I would be carefull as to what you replace the gears with. Make sure the shafts 
>and the motors can handle the extra weight that a metal gear would present. I 
>might sugggest usig a gear made of Delrin instead of metal, unless it is a 
>lightweight metal like aluminum. Small Parts Inc in Miami has a nice selection of 
>Delrin gears that might fit. 
>
>Delrin offers more strength and durability over that of nylon which is commonly 
>used plastic for cheap gears. 
>
>james
>
>On 10 Oct 2006 at 14:25, Rogelio Perea wrote:
>
>> Been thinking of replacing that plastic gear with something more solid but
>> it is one of those projects...
--

Australia isn't "down under", it's "off to one side"!

stanblaz at netspace.net.au
www.cobracat.com (home of the Australian Cobra Catamaran)
www.parkdaleyc.com (where most of them sail)
http://groups.yahoo.com/group/cobra-cat/