[Coco] DCModem Pak to RS232 conversion posted

[Benoit Bleau]

If someone were to use the DCModem Pak in Nitros9 (OS-9), shouldn't then
skip the address re-mapping?  Wouldn't it be better to use the correct
device descriptor instead?  This way, you could use the DP and an RS-232
pack at the same time , in a multipak...

-Ben

> -----Original Message-----
> From: coco-bounces at maltedmedia.com [mailto:coco-bounces at maltedmedia.com]
> On Behalf Of Robert Emery
> Sent: Thursday, September 23, 2004 4:28 PM
> To: CoCoList for Color Computer Enthusiasts
> Subject: Re: [Coco] DCModem Pak to RS232 conversion posted
> 
> 
> --- "John R. Hogerhuis" <jhoger at pobox.com> wrote:
> 
> > The design depends on a simple level converter pcb that was sold by
> > CocoPRO!
> 
> Not quite... although CoCoPRO! offered it as a kit, you can see that it is
> nothing more than perfboard. The schematic is so simple that no PC board
> is
> really even needed.
> 
> I am going to do this mod to my DC Modem, will report the results. If
> parts are
> available to me (and I believe they are) and there is sufficient interest,
> I
> will offer a similar kit, and with options I mentioned in my earlier post.
> 
> Also I will gladly perform this mod or other hardware services for CoCo-
> nuts.
> Let me check out the parts scene and figure out $$$.
> 
> Bob Emery
> 
> 
> 
> 
> _______________________________
> Do you Yahoo!?
> Declare Yourself - Register online to vote today!
> http://vote.yahoo.com
> 
> --
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco