[Coco] Re: Coco on a SVGA monitor using the Xrgb-2 Plus

[Bob Devries]

The daughter board is a plug in module, but you have to remove the
motherboard from the computer to do it :-(

--
Regards, Bob Devries. Dalby, Queensland, Australia.
Faith isn't faith until it's all you're holding on to.
http://e4god.com/freeblogs/bdevries/


----- Original Message ----- 
From: "Robert Emery" <theother_bob at yahoo.com>
To: "CoCoList for Color Computer Enthusiasts" <coco at maltedmedia.com>
Sent: Monday, September 13, 2004 2:48 AM
Subject: Re: [Coco] Re: Coco on a SVGA monitor using the Xrgb-2 Plus


>
> --- Torsten Dittel <Torsten at Dittel.info> wrote:
>
> > > Just a guess, but can you remove the PAL circuitry temporarily?
> > Hmm... I guess I don't understand exactly what you mean. The Australian
> > ROMs are patched to initialize the GIME at 50 Hz, although 60 Hz would
> > do as well with both monitor types. The PAL stuff is in the Composite
> > Satellite Board. Do you mean I should remove that stuff?
> > Torsten
> >
> I mean the whole daughterboard... I suspect it's circuitry may be causing
your
> jittery signal on the "weaker" monitor... can you remove the whole PAL
> daughterboard and just use RGB by itself? I'm looking at the CoCo3
techref, but
> can't tell if that's soldered in or what.
>
> Bob
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - 50x more storage than other providers!
> http://promotions.yahoo.com/new_mail
>
> -- 
> Coco mailing list
> Coco at maltedmedia.com
> http://five.pairlist.net/mailman/listinfo/coco
>